Caravan Cleaning

Guide · Caravan owners · 4 min read · Updated 16 November 2026

How to Remove Black Streaks from a Caravan or Motorhome

Short answer

Black streaks are caused by dirt and pollution washed down from the roof, awning rails and window frames. Remove them by rinsing the panel, applying a dedicated caravan-safe black streak remover, agitating gently with a soft sponge or microfibre mitt, then rinsing thoroughly. Avoid abrasive pads, harsh solvents and high-pressure jets near seals. A wax or sealant afterwards helps stop streaks returning.

A caravan parked on a road

What causes black streaks?

Black streaks are one of the most common complaints from caravan and motorhome owners. They form when rainwater runs across the roof, picks up traffic film, soot, tree sap and other pollution, and then runs down the sides, usually from the corners of the roof, the ends of awning rails, window frames, roof lights and the edges of decals. As the water evaporates it leaves the dirt behind in long dark lines. Over time the residue bonds to the surface and becomes harder to shift.

Vans stored under trees or near busy roads tend to suffer most, and streaks show up badly on white and light-coloured panels.

What you need

Using the right products protects the bodywork, seals and acrylic windows, which are easily scratched or crazed by the wrong chemicals. Buy products labelled as safe for caravans and motorhomes and read the instructions before use.

  • A dedicated caravan-safe black streak remover
  • A pH-balanced caravan or vehicle shampoo
  • Two buckets, one for wash solution and one for rinsing the mitt
  • Soft microfibre wash mitts and sponges, never abrasive pads
  • A long-handled soft brush for upper panels
  • A hose with a gentle spray, or low-pressure rinse
  • Microfibre drying towels and a caravan-safe wax or sealant

Step-by-step method

Work in the shade if possible, on a cool panel, so the products do not dry before you rinse them. Start by rinsing the whole side of the van with plenty of water to remove loose grit, which would otherwise scratch the surface during washing. Apply the black streak remover to a section of streaks, following the product's dwell time, and agitate gently with a soft sponge or mitt. Do not let it dry. Rinse thoroughly, working from the top down.

Once the streaks are gone, wash the whole van with a pH-balanced shampoo using the two-bucket method, which keeps grit out of your wash water. Rinse again, dry with microfibre towels to avoid water spots, and finish with a caravan-safe wax or sealant.

StepActionTip
1Rinse the whole panelRemoves grit that could scratch
2Apply black streak removerWork a section at a time; follow dwell time
3Agitate gentlySoft mitt or sponge only
4Rinse thoroughlyTop down, do not let product dry
5Wash with shampooTwo-bucket method
6Dry and protectMicrofibre towels, then wax or sealant

What not to do

Many caravans have been damaged by well-meant cleaning. Avoid household cleaners, bleach and solvents such as white spirit or thinners, which can strip protective coatings, stain decals and attack the sealants around windows and joints. Never use these on acrylic windows, which can craze, a network of fine cracks that cannot be polished out. Do not use scouring pads or stiff brushes on panels, as they leave fine scratches that trap dirt and make streaks worse in future.

Be careful with pressure washers. A high-pressure jet held close to seals, vents, window frames or decals can force water into the structure or lift edges. If you use one, keep it on a low setting, hold the lance well back from the surface and avoid seals and joints altogether.

Stopping black streaks coming back

Streaks will always return to some degree, but you can slow them down a great deal. Fitting streak-prevention extenders or spouts to the ends of awning rails directs rainwater away from the side panels. Parking away from trees helps, as does a breathable cover or a covered storage space over winter. Most importantly, a wax or sealant gives the panels a slick surface that dirt cannot grip so easily, so streaks rinse off with the next wash rather than bonding to the surface.

Regular washing makes a big difference. Little and often is easier, and gentler on the van, than an annual battle with deeply ingrained streaks.

Different panel materials need different care

Not every part of a caravan is made of the same material, and each reacts differently to products and pressure. Side panels on most tourers are painted aluminium, which tolerates a careful wash well but can be scratched by grit or abrasive pads. Front and rear panels, roof mouldings and wheel spats are usually GRP or ABS plastic, which can fade and oxidise and may need a different polish. Decals and graphics are vinyl, and their edges can lift if a strong solvent or a close pressure jet gets under them.

Windows and roof lights are acrylic, the most delicate material of all. Black streaks that run across acrylic should be removed with a product made for acrylic and a clean, soft cloth, never the same mitt used on the panels, which may carry grit. If you are unsure what a section is made of, check your handbook or ask a professional before using anything stronger than a gentle shampoo.

When to call in a professional

If streaks remain after a careful attempt, or the panels look dull and chalky even when clean, the surface may be oxidised. That needs machine polishing, which is best done by someone experienced with caravan materials, as GRP, painted aluminium and acrylic each need different compounds and pressure. A professional touring caravan exterior wash with streak treatment costs £60 to £110, and polish and protect £180 to £350. Professionals also have platforms and long-reach tools for upper panels, which avoids leaning ladders against the van.

Questions people also ask

Can I use washing-up liquid on my caravan?

It is best avoided. Washing-up liquid is designed to strip grease and can remove wax and sealant protection from the panels, leaving them more vulnerable to streaks and oxidation. Some products also contain salt, which is not good for metal parts. A pH-balanced caravan or vehicle shampoo is gentler and leaves protection in place.

Why do black streaks keep coming back so quickly?

Usually because the surface has lost its protection, so dirt bonds to it easily, or because water from awning rails and roof corners is running straight down the sides. Applying a wax or sealant after cleaning and fitting rail extenders or spouts to divert water both help. Parking away from trees also reduces streaking.

Is a pressure washer safe on a caravan?

It can be used carefully on a low setting, held well back from the surface, but it is easy to force water past seals, vents and window frames or lift decal edges. Many owners and professionals prefer a gentle hose and soft brushes. Never aim a high-pressure jet directly at seals or joints.

Written and checked by the Caravan Cleaning team. Read our editorial policy.

Get a free caravan cleaning quote

Tell us what you need and we'll come back with a clear price.

Request a quote